Wait up to 10 minutes to remove the premask. Spray and apply this section just as you did the other. Now remove the tape hinge and peel away the release liner on the other side of the decal. Hold the end of the decal several inches away from the surface and slowly lay the vinyl down from the hinge outward and firmly squeegee over the premask with short overlapping strokes. Be sure not to get any fluid on the remaining release liner on the other side of the hinge. Lightly spray the vehicle surface with Rapid Tac (or soap and water). You can spray your vehicle, the vinyl, and the premask, but never the backing paper. Save the release liner, you'll need it again in a minute.Ĭaution:During this step do not get the backing paper wet, it will ruin your decal. Temporarily tape the peeled section to the surface of your car and cut away the release liner with scissors or an exacto knife. Remove the positioning tape you placed on the corners and hold down the release liner while slowly peeling the premask away back towards the hinge.
This creates a hinge allowing the graphic to be applied one section at a time. Now apply strips of masking tape vertically over the center of the decal. Wipe away any residue or streaks on your vehicle left from step one using Rapid Tac (or soap and water). Determine the location you'd like to apply the decals to by carefully measuring each into place and then secure them down with a piece of masking tape on each corner. Once marked, trim your decals with pair of scissors or an exacto knife. Either measure your vehicle or lay the graphics on your automobile and mark where excess material will need to be trimmed off. Unroll your decals on a clean flat surface and allow them to stretch out for a few minutes. Repeat with Rapid Prep (or alcohol) one more time. Then spray the application surface with Rapid Prep (or alcohol). Using a plain white household paper towel thoroughly wipe the surface from center outward until dry. If possible, application should be done in a garage or controlled environment to avoid contaminants that can be present outdoors.īegin by washing your vehicle as you normally would, but do not wax afterward. The application surface should be between 50-90 degrees fahrenheit. Note: if you choose to use soapy water it should be made with 8 drops of Dawn Original Formula Dish Soap per 32 oz of water (large sprayer size). You will need a squeegee, masking tape, plain white paper towels, scissors, exacto knife, pin, measuring tape, pencil, Rapid Tac (or soapy water) and Rapid Prep (or alcohol). Tools Needed to Apply Your Racing Stripes The bottom layer is the release liner (backing paper). The adhesive side of the vinyl faces downward. The top layer of your graphic is the application tape (premask). Our in depth installation guide continues below. This video provides a quick overview of the decal application process.
CAR RACING STRIPES INSTALL
This is bottom up sweater with a fitted sleeve and buttoned neck opening.How to Install Vinyl Racing Stripes and Apply Car Decals Basic Vinyl Racing Stripe Installation Video Just remember, if you make it for a tiny tot, you will to replace the buttons with emrboidered wheels. It can be made in five sizes ranging from age 1-9 years and is knit in DK weight yarn.įor a personal touch, why not give your little one the opportunity to choose the colour of the cars? Alternatively, you could take a look through your stash to see if you already have some suitable options on hand. How much fun is this super-cute Racing Car sweater? A smart and trendy design that also offers plenty of zooom.
0 kommentar(er)
